![make aligned drill holes in estlcam make aligned drill holes in estlcam](https://www.estlcam.de/pic/hilfe/freifraesen.gif)
Remove all the branches and carefully lay them out in the order in which you had them placed on the rod.ġ5. I decided to leave about 3 inches on top to put the starfish.ġ4. When all the branches are in place, mark the threaded rod with a sharpie at the point where you want to cut the excess.
![make aligned drill holes in estlcam make aligned drill holes in estlcam](https://www.brilliantdiy.com/wp-content/uploads/2016/11/Drill_Straight_holes_without_a_Drill_Press.png)
Continue drilling and placing the branches until they are all done.ġ3. Later you can adjust the pieces for best placement and secure them with a glue gun if you wish. Don’t secure the pieces as they will need to be removed in order to cut the rod to its final size. Then just slide the drilled branch onto the threaded rod. If you make a V shaped groove in the block, it will be easier to hold the pieces still when you drill them.ġ1. Hold each piece against a block of scrap wood when you drill the hole. Hold each branch in place to get an idea of where you want to drill the hole and mark where you want to drill the hole.ġ0. Lay out the pieces for the rest of the tree according to length, with the smallest at the top.ĩ.
#Make aligned drill holes in estlcam crack#
Do not tighten it too much or it could crack the wood.Ĩ. Tighten the nut at the top until the two pieces are tight and stable. This is why you want to counterbore a hole. Make sure that the hardware does not stick out past the bottom or the tree will not stand up. Put on a washer followed by a lock washer and then finally a nut. Insert this into the top piece of the base and then put the bottom piece on.ħ. The lock washer will help keep it from loosening up over time.Ħ. Next put the nut, lock washer and washer on the threaded rod – in that order. So, here you see a counterbored hole in both the bottom and top of my base pieces.ĥ. I also counterbore the hole on the top part of the base to hide the nut. Next, using the Forstner bit, you will want to enlarge the hole on the bottom part of the base just deep enough so that when you screw in the nut it will not stick out and the base will will sit flat.Ĥ. When you put them onto the threaded rod, this is how they will be aligned.ģ. Hold the base pieces together exactly the way you will want them to be positioned, and drill through both of them together.
![make aligned drill holes in estlcam make aligned drill holes in estlcam](https://images-na.ssl-images-amazon.com/images/I/61SU5z29f%2BL._SL1500_.jpg)
![make aligned drill holes in estlcam make aligned drill holes in estlcam](https://us1.dh-cdn.net/uploads/db5587/optimized/2X/0/07f1c67d2f902d8daddc9688e3224e551a005365_2_690x500.jpeg)
I ended up turning a branch so that the base would at least have three points to rest on.Ģ. If you are lucky, you can use a curved piece to fit over the very bottom piece. Choose the two largest pieces for the base of your driftwood Christmas Tree. Steps for Creating Your Driftwood Christmas Tree:ġ.